DenTek® Temparin® Max Advanced Repair Kit

Temparin Max Advanced Repair Kit FOP
Temparin Max Advanced Repair Kit BOP
Temparin Max Advanced Repair Kit FOP
Temparin Max Advanced Repair Kit BOP

DenTek® Temparin® Max Advanced Repair Kit

Temporarily hold lost fillings and inlays in place until you have a chance to visit the dentist with DenTek® Temparin® Max Advanced Repair Kit.

Available in two sizes: 2.64g (13+ repairs) and 1.1g (5+ repairs)

Contains the same maximum-strength ingredients dentists use.

Temporarily repairs lost fillings, caps, crowns, or inlays

Should only be removed by a dental professional, who should be seen within 48 hours of use

  • Directions to replace a lost filling: Wash the cavity area with warm water and do not dry. Cut with spade tool or pinch a small amount of DenTek® Advanced Repair from the vial, and roll into a ball between fingers. Slightly overfill the cavity with DenTek® Advanced Repair and tamp into place with applicator tool tip. Close your teeth together, as if you were biting down on a piece of paper, and gently chew or grind on the replaced filling a couple times to create a comfortable bite. Use a moist cotton swab to remove excess DenTek® Advanced Repair from around the area. Moisture will accelerate the set. DenTek® Advanced Repair will set softly in your mouth within a few minutes, but avoid chewing on the repair for 2-3 hours to allow the material to fully set.

    Directions to secure loose crowns, caps, or inlays: Try the crown, cap, or inlay first to see if you can fit it accurately back onto the tooth surface. If you are not able to do so, or if remaining tooth is cracked, then do not proceed further. If the crown has a post attached to it or if there is tooth surface remaining inside the crown, DenTek® Advanced Repair may not adhere. Carefully rinse the tooth area and the inside of the crown, cap, or inlay with warm water, and do not dry. Cut with spade tool or pinch a small amount of DenTek® Advanced Repair from the vial, roll into a ball between fingers, and place evenly inside the crown, cap, or inlay. Place the crown, cap, or inlay on the tooth and bite down, applying pressure to push into position. DenTek® Advanced Repair will begin to harden within a few minutes, but avoid chewing on the repair for at least 2-3 hours to allow the material to set. Use a toothbrush to gently clear any excess material from around the crown, cap, or inlay.

  • Zinc Oxide Powder, Calcium Sulfate, Petroleum Jelly, Potassium alum, Paraffin, Aluminum Sulphate, Aluminum Phosphate, Menthol Crystals, Eugenol, Yellow Iron Oxide

  • To avoid infection and/or serious injury, this product should not be used if there is throbbing pain, ulceration or swelling in the affected area. If any of these symptoms exist, consult your dentist immediately. This product should not be placed on open wounds. Do not use if allergic to Eugenol. READ ALL OF THE DIRECTIONS CAREFULLY BEFORE USE! Wash and dry your hands. Do not get unused Temparin Max wet. Use only what is needed to repair the dental emergency, and save the rest for a future application.

    KEEP OUT OF REACH OF CHILDREN.